Micro screws serve consumer electronics and wearables, contacting sweat, humidity and cleaners; coating corrosion resistance directly affects appearance and reliability. Salt spray and artificial sweat tests evaluate the two environments—marine atmosphere and human contact. This guide covers conditions, judgment and common issues.
The mechanisms differ: salt spray is mainly electrochemical, while artificial sweat contains chloride and organic acids, eroding closer to daily wear. They are not interchangeable.
Neutral salt spray commonly follows GB/T 10125 and ISO 9227 with sodium chloride solution at neutral pH, chamber temperature around 35°C and controlled fallout rate.
Evaluation covers appearance rating and time to corrosion. Ratings reference GB/T 6461 or ISO 10289 by corroded area; products with thickness and durability requirements may use copper-accelerated or acid salt spray.
Solutions follow standard formulas mimicking sweat pH and salinity; tests use immersion or wiping at temperatures and durations set by use case. Wearables often run immersion and wet-dry cycles to simulate sweating and drying.
Post-test checks cover discoloration, blistering, pitting and base-metal rust, especially recesses and thread roots where sweat accumulates. Criteria are agreed with the customer and product spec.
Sample randomly from production batches, not by hand-picking. Clean oil and fingerprints with ultrasonic ethanol and dry before testing. Quantity follows standards or customer requirements.
Place specimens apart without shading or contact, recesses up to mimic liquid retention. Chamber position affects corrosion, so rotate or record positions.
Inspect at agreed intervals and record first corrosion time and location. Appearance ratings use corroded area; functional judgment uses thread driveability and assembly impact.
Records include standard, concentration, pH, temperature, fallout, quantity and results for reproducibility and audits. Keep specimens and photos when anomalies occur.
Typical failures are pitting, thread-root rust and recess discoloration. Pitting links to porosity, thin coating or poor pretreatment; thread roots trap liquid and corrode first.
Deep recesses get uneven, thin coatings. Analyze with thickness measurement and cross-sections to separate pretreatment, plating and passivation issues.
Improvements include thicker, more uniform coatings, better pretreatment and passivation, and sealing coats on vulnerable areas. For sweat, use more resistant systems or stainless.
Structure and assembly matter too—recess drainage via shape optimization and sealing. Feeding results back to process and design builds a stable corrosion-resistant scheme.
Calibrate temperature, salinity and fallout regularly; clogged nozzles cause uneven spray and result scatter. Confirm chamber cleanliness to avoid salt residues altering concentration.
Sweat tests need pure water and reagents, freshly prepared solutions—standing changes pH. Avoid metal contamination in containers that adds corrosion sources.